FAQ

Does Not Feed Material

Does Not Feed Material

Does Not Fit The Mold

Does Not Fit The Mold

Hydraulic oil temperature is too high

Hydraulic oil temperature is too high

No injection or slow speed

No injection or slow speed

No Pre-molding or Pre-molding Too Slow

No Pre-molding or Pre-molding Too Slow

Oil Pump Motor Does Not Start

Oil Pump Motor Does Not Start

Semi-automatic operation failure

The semi-automatic operation of the injection molding machine is to open the safety door, close the travel switch, send a signal to the machine to start the semi-automatic action, and then close the mold.

The Large Pump Cannot Produce Pressure

The motor can rotate, but there is no pressure or the large pump cannot produce pressure.

The Mold Cannot Be Adjusted or Is Difficult To Adjust

The mold cannot be adjusted or is difficult to adjust